Cylinder Mower Blade High-speed Rotation Output Speed Greatly Improved

Cylinder Mower Blade also called from the weeding machine, Cylinder Cylinder Mower Blade Blade, 1805 years there, when the lawn Cylinder Mower Blade is human, no power support. In 1805 the British Pramakette invented the first harvest of grain and can cut the weeds of the machine, by the people to promote the machine, through the gear drive to spin knives, which is the prototype of the lawn Cylinder Mower Blade. 1830 British textile engineer Bill - Pudding made a lawn Cylinder Mower Blade patent.

Modern Cylinder Mower Blade consists of cutterhead, engine, walking wheel, walking mechanism, blade, handrail and control part. It is composed of parallel four-pole lifting device, frame, left and right wing weeding device, whole machine deviation device, comb tooth rotation bevel gear speed transmission mechanism and comb tooth type deepening device; efficiency is higher than artificial weeding 8 to 10 times, widely used for pruning lawns, vegetation and so on. Cylinder Mower Blade has a diesel engine and gasoline engine, the blade using the engine's high-speed rotation output speed greatly improved, saving the sheltered workers operating time, reducing a lot of human resources. The research of new lawn Cylinder Mower Blade is developing in the direction of high speed and energy saving.

How to use Cylinder Mower Blades and maintenance properly?

1. Cylinder Mower Blade before mowing, you must first remove the debris in the mowing area, so as not to damage the grass head, blade. Chiller start the engine, you should first close the damper, start and then open the damper. If the turf area is too large, Cylinder Mower Blade continuous working hours is best not more than 4 hours.

3. Before using the lawn Cylinder Mower Blade, check the oil level to see if it is between the upper and lower scales of the oil scale. 5 hours after the use of new machines should be replaced with oil, the use of 10 hours after the oil should be replaced once again, according to the requirements of the manual after the regular replacement of oil. Replace the oil should be in the engine in a heat state. Filling the oil can not be too much, otherwise it will appear: black smoke, lack of power (cylinder coke too much, spark plug gap small). Engine overheating and so on. Filling the oil can not be too little, otherwise it will be the engine gear noise, piston ring to accelerate wear and damage, and even Lawa and other phenomena, resulting in serious damage to the engine.

4. Maintenance of the air filter Before and after use, check whether the air filter is dirty and should be cleaned. If the dirty will lead to the engine is difficult to start, black smoke, lack of power. If the filter is a sponge, can be cleaned with gasoline, the appropriate filter on the filter some oil, so that the filter to keep the wet state, but also to keep the filter in the air, Is conducive to adsorption of dust.